What slab leveling is

Slab leveling, also called slab jacking or slabjacking, is lifting a sunken concrete slab back toward level by pumping material under it through holes drilled in the slab. The material fills the empty space that opened up under the concrete and raises the slab without tearing it out.

The material is either a cement slurry, which is mudjacking, or expanding polyurethane foam, which is polyjacking or foam jacking. The job also goes by concrete leveling, concrete lifting, and concrete raising.

Cross-section of a sunken concrete slab being lifted: a hose pumps material through a hole drilled in the slab, the material fills the void underneath, and arrows show the slab rising back toward level.
Material pumped through a hole fills the space under the slab and pushes it back up toward level.

On an ordinary slab the work takes a few hours, and a cement slurry sets over roughly the next day.

This page is about the job: which slab, which way it moved, and whether to lift or replace it. How mud and foam compare, step by step and side by side, is in the mudjacking guide.

Which slabs can be leveled

Almost any flat concrete around a house can be lifted, as long as it is still in good shape and it sank rather than rose.

  • Sidewalks and front walks.
  • Driveways, including a single section that dropped at the garage or the street.
  • Patios.
  • Garage floors.
  • Pool decks.
  • The slab your house sits on, which is a different job with different stakes. It has its own section below.

What decides the fit is the slab's condition. A good candidate is sound concrete in one piece or a few large pieces, that dropped because the ground under it settled or washed out, and that has since stopped moving.

Did it sink, or was it pushed up?

This is the check that matters most in central Oklahoma. Slab leveling fixes a slab that dropped. It does nothing for a slab that the ground pushed up.

InterNACHI, the home inspectors' association, lists concrete that has risen because of expansive soil among the cases where mudjacking doesn't work. Pumping more material under a high spot only makes it higher.

Central Oklahoma clay swells when it gets wet and shrinks when it dries, so the same yard can do both. The OKC soil guide explains why the local ground moves.

How to tell which way yours moved

  • Compare the out-of-line piece with things that don't move much, like the house foundation, the garage floor, or the street curb.
  • If it sits lower than everything around it, or it slopes down toward one corner, it most likely sank.
  • If it sits higher than its neighbors, or its middle bulges up, the ground may have pushed it up.
  • Watch it through a wet spell and a dry spell. A slab that rises after rain and drops in a drought is riding the clay, and lifting it won't settle that.

If you can't tell, ask the contractor before they drill: "Did this slab sink, or was it pushed up, and how do you know?" A good contractor answers that question before quoting a lift.

Lift it or replace it

Lifting usually wins on price. InterNACHI puts mudjacking at roughly half the cost of replacing the concrete, since no old concrete comes out and little new material goes in.

When lifting fits, and when replacement is the better call.
Deciding factorLift itReplace it
The concreteSound, in one piece or a few large piecesCrumbling, flaking, or broken into many pieces
Which way it movedIt sankSwelling clay pushed it up, so lifting won't bring it down
The ground under itSettled or washed out, now stableSwampy, or a sinkhole
CostRoughly half the cost of replacementTear-out plus a new pour
TimeA few hours; slurry sets over about a dayTear-out, a new pour, and time for the concrete to cure

The lift-it limits and the cost and time comparison follow InterNACHI's mudjacking guide.

One rule applies either way. If nobody has found out why the slab moved, a new slab can move the same way the old one did. Replacing the concrete doesn't fix the ground.

Can you level a slab yourself?

On a small outdoor slab, you can. The savings are smaller than they look, and the mistakes are hard to undo.

DIY mudjacking

Angi puts equipment rental, materials, and safety gear for a DIY mudjacking job at $500 to $1,200. That is close to what a pro charges for a small job, and it takes a high-powered pump and a feel for how the slab responds.

DIY foam kits

The foam rigs professionals use generally can't be rented. A few companies sell 2-part spray-foam kits straight to homeowners instead. Secure Set, an Oklahoma City maker, lists its 16.6 cubic foot kit at $503.95, with the hose and gun included (checked Sep 2026).

What can go wrong either way

  • Too much material can bulge or crack the slab you meant to fix.
  • Slurry or foam can get into cracked utility lines running under the slab.
  • The slab can come up unevenly, one of the DIY risks Angi lists.

The first 2 risks are the ones the Foundation Performance Association's repair committee names for professional mudjacking and foam, so they apply at least as much to a first-timer.

2 cases are never DIY jobs: a slab that was pushed up rather than sank, and the slab your house stands on.

What slab leveling costs, slab by slab

Nationally, a typical slab jacking job costs about $500 to $1,900, according to Fixr's 2026 cost data. The slab and its size move the price more than anything else.

National ballparks by slab, for sizing a job before you get a bid.
SlabTypical sizeMudjacking (US)Foam per sq ft (US)
Sidewalk50 - 150 sq ft$300 - $900About $5
Patio100 - 300 sq ft$500 - $1,500About $10
Driveway200 - 600 sq ft$800 - $2,400Not broken out
Garage floor150 - 400 sq ft$700 - $2,000Not broken out
Pool deck150 - 500 sq ft$800 - $2,500About $10
House slabVariesPriced after the cause is diagnosedAbout $25

Mudjacking figures are from Angi's 2026 mudjacking cost guide (updated Aug 2026); foam figures are from Angi's polyurethane lifting cost guide (updated Sep 2026). Both are national.

Small jobs cost more per square foot. In the same Angi data, a 50 sq ft slab runs $12 to $14 per sq ft, while an 800 sq ft job drops to $3.50 to $5, and many companies charge a minimum of around $500.

Foam costs more than mud across the board, about $5 to $25 per sq ft. The mudjacking guide's cost section has the full mud-vs-foam price table.

Closer to home, one Oklahoma franchise of a national repair chain publishes an average of $1,000 to $3,000 for residential foam injection.

For OKC prices across every repair type, with dated homeowner reports, see the cost guide.

How long it lasts, and why water decides

There is no honest fixed number of years. How long a lift lasts depends more on the soil under the slab than on what was pumped into it.

The Foundation Performance Association's repair committee groups mudjacking and foam together as shallow repairs affected by active, moving soil. If the moisture in that soil changes, the slab can move again.

The cost guides say the same. Angi notes that mudjacked slabs may settle again if the soil shifts or water problems persist, with re-leveling or new-crack repairs running $300 to $800. Foam can outlast the concrete it lifts, but only when the drainage problem is fixed at the same time.

The engineering standard backs trying drainage and watering fixes before structural repair. For a slab, that means:

  • Downspouts that empty well away from the concrete.
  • Soil graded so rain runs away from the slab.
  • Steady watering near the house foundation in a drought, so the clay doesn't shrink hard.

Ask any contractor the same question: what is the plan for the water under this slab? If there is no answer, the lift may be temporary.

◆ Before anyone drills

The house slab is a different job

For a walk, patio, or driveway, a reputable contractor can size the lift. For the slab your house stands on, the first question is whether it sank or was pushed up, and that is an engineer's call.

The engineering standard also warns against pumping grout or slurry under a house slab that already sits on repair piers if the soil there can still swell enough to damage the house.

An independent structural engineer's report runs $200 to $500 and names the problem and the fix, from someone with no repair to sell. In OKC, one homeowner's engineer inspection and detailed report came to about $200 plus $200.

The house leveling guide covers what leveling a whole house involves and costs.

Read the engineer-first guide →

Want a price on your slab? 1 OKC contractor, not 5.

Free to you. The contractor pays us a referral fee, never a markup.

FAQ

How much does slab jacking cost?

Nationally, a typical slab jacking job costs about $500 to $1,900, according to Fixr's 2026 cost data. By slab, Angi's 2026 mudjacking figures run about $300 to $900 for a sidewalk, $500 to $1,500 for a patio, $800 to $2,400 for a driveway, and $800 to $2,500 for a pool deck. Polyurethane foam costs more, about $5 to $25 per square foot. These are national figures, so an OKC quote can land higher or lower.

How long does slab jacking last?

There is no fixed number of years. Slab jacking is a shallow repair: the slurry or foam sits in the same soil that let the slab sink, so if that soil gets much wetter or drier, the slab can move again. The lift lasts longest when the water problem behind the sinking is fixed at the same time. Ask the contractor what the plan is for drainage, and what the warranty covers if the slab settles again.

Can I do DIY concrete slab jacking myself?

On a small outdoor slab, yes, but the savings are smaller than they look. Angi puts DIY mudjacking equipment rental and materials at $500 to $1,200, and one DIY spray-foam kit lists at about $504. A mistake can lift the slab unevenly, crack it, or push material into cracked utility lines under it. Don't try it on a slab that was pushed up rather than sank, or on the slab your house sits on.

Does slab jacking work?

Yes, on a sound slab that sank because the ground under it settled or washed out, and it usually costs about half as much as replacing the concrete. It doesn't work on a slab that swelling clay pushed up, on crumbling or badly broken concrete, or when nobody has fixed the water that caused the sinking.

Is slab leveling the same as mudjacking?

Slab leveling and slab jacking are names for the job: lifting a sunken concrete slab back toward level. Mudjacking is one way to do it, with a cement slurry. Polyjacking, or foam jacking, does the same lift with expanding polyurethane foam. Both are shallow repairs with the same basic limits.